美军弹药包装设计与试验要求

靳跃钢; 高海波; 赵耀辉; 白涛; 张学金

引用本文:

【打印本页】【下载PDF全文】【查看/发表评论】【EndNote】【RefMan】【BibTex】

←前一篇|后一篇→

过刊浏览高级检索

本文已被：浏览 2533次下载 1945次	码上扫一扫！
分享到：微信更多字体:加大+\|默认\|缩小-
美军弹药包装设计与试验要求
靳跃钢¹, 高海波², 赵耀辉³, 白涛³, 张学金³
1.中国兵器工业集团公司 137 厂, 张家口 075000;2.总装驻重庆地区军代室, 重庆 400039;3.中国兵器工业第五九研究所, 重庆 400039

摘要:

分析了 MIL-STD-1904A,MIL-STD-1660,MIL-STD-648D 等多个美军弹药包装相关标准、规范,归纳出了弹药包装在防护级别、防护有效期、环境适应性、单元化、包装容器和试验验证等方面的设计与试验要求,研究表明美军弹药包装防护级别不同,相应的设计试验要求也不同。

关键词: 美军弹药包装设计试验

DOI：

分类号:TB487

基金项目:

Design and Test Requirements of US Military Ammunition Packaging

JIN Yue-gang¹, GAO Hai-bo², ZHAO Yao-hui³, BAI Tao³, ZHANG Xue-jin³

1.No. 137 Factory of China Ordnance Industry Corporation, Zhangjiakou 075000, China;2.Chongqing Military Representative Office of GAD, Chongqing 400039, China;3.No. 59 Institute of China Ordnance Industry, Chongqing 400039, China

Abstract:

Standards and specification of US military ammunition packaging, such as MIL-STD-1904A, MIL-STD-1660, and MIL-STD-648D were analyzed. The requirements of design and test in aspects of protection grade, protection period, environmental worthiness, unitization, packaging container, and test verification were induced. It was concluded that the requirements and test verification contents vary with different protection packaging grade in US ammunition packaging.

Key words: US military ammunition packaging design test