文章摘要
王丽梅,邓开发.助剂对水性塑料凹印油墨干燥速度的影响[J].包装工程,2014,35(23):126-129.
WANG Li-mei,DENG Kai-fa.Effect of Auxiliary on Drying Rate of the Water-based Plastic Gravure Inks[J].Packaging Engineering,2014,35(23):126-129.
助剂对水性塑料凹印油墨干燥速度的影响
Effect of Auxiliary on Drying Rate of the Water-based Plastic Gravure Inks
投稿时间:2014-01-12  修订日期:2014-12-10
DOI:
中文关键词: 水性塑料凹印油墨  干燥速度  pH稳定剂  增稠剂  分散剂  润湿剂
英文关键词: water-based plastic gravure ink  drying rate  pH stabilizer  thickener  dispersant  wetting agent
基金项目:
作者单位
王丽梅 上海理工大学上海 200093 
邓开发 上海理工大学上海 200093 
摘要点击次数:
全文下载次数:
中文摘要:
      目的 研究水性塑料凹印油墨中各种助剂的不同添加量对油墨干燥速度的影响。方法 保持水性凹印油墨中颜基比不变, 只改变 1 种助剂的含量比例,采用高速研磨的方法制备塑料水性凹印油墨样品, 并通过测试各油墨样品的初干性和黏度, 探讨不同质量分数的各助剂对油墨干燥速度的影响。结果 适量的助剂用量对油墨的干燥速度有一定的提高, 过多的添加则会降低油墨干燥速度。结论 pH稳定剂、 增稠剂、 分散剂和润湿剂的质量分数分别为0.2%, 0.6%, 3.0%和2.0%时, 不但能相应地提高干燥速度, 而且不会对油墨的其他性质如黏度、 附着牢度等产生不良影响。
英文摘要:
      Objective To study the influence of different addition amount of auxiliary on the dryness of water-based plastic gravure ink. Methods Sample ink of plastic aqueous ink was prepared by means of high-speed grinding dispersal. All the sample ink pigment/binder ratios were the same and only an additive changed its content. The different contents of auxiliary were analyzed by the way of measuring rough dryness of sample ink. Results Suitable dosage increased the drying rate of ink, while unsuitable dosage decreased the drying rate. Conclusion When the contents of pH stabilizer, thickener , dispersant and wetting agent were respective 0.2%, 0.6%, 3.0% and 2.0%, the drying rate of the water-based plastic gravure ink increased, and meanwhile its qualities including viscosity and adhesion were not negatively affected.
查看全文   查看/发表评论  下载PDF阅读器
关闭

关于我们 | 联系我们 | 投诉建议 | 隐私保护 | 用户协议

您是第20809110位访问者    渝ICP备15012534号-2

版权所有:《包装工程》编辑部 2014 All Rights Reserved

邮编:400039 电话:023-68795652 Email: designartj@126.com

    

渝公网安备 50010702501716号