文章摘要
宋海燕,田萌萌,伍亚云.蓄冷剂质量对挤塑聚苯乙烯保温箱温控效果的影响研究[J].包装工程,2016,37(7):56-60.
SONG Hai-yan,TIAN Meng-meng,WU Ya-yun.Influences of the Coolant Amount on Temperature Control Effect of Extruded Polystyrene Insulation Box[J].Packaging Engineering,2016,37(7):56-60.
蓄冷剂质量对挤塑聚苯乙烯保温箱温控效果的影响研究
Influences of the Coolant Amount on Temperature Control Effect of Extruded Polystyrene Insulation Box
投稿时间:2015-07-20  修订日期:2016-04-10
DOI:
中文关键词: 挤塑聚苯乙烯  蓄冷剂  保温箱  温控效果
英文关键词: extruded polystyrene  coolant  insulation container  temperature control effect
基金项目:“十二五” 国家科技支撑计划 (2015BAD16B05);天津市科技攻关计划 (06YFGPNC03400)
作者单位
宋海燕 天津科技大学天津 300222 
田萌萌 天津市汇源印刷有限公司天津 300308 
伍亚云 天津科技大学天津 300222 
摘要点击次数:
全文下载次数:
中文摘要:
      目的 研究蓄冷剂质量对挤塑聚苯乙烯保温箱温控效果的影响。方法 在3种不同的外界温湿度环境条件下, 向保温箱内部加入不同质量的蓄冷剂, 研究蓄冷剂质量对挤塑聚苯乙烯保温箱温控效果的影响。结果 加入不同蓄冷剂质量时, 保温箱内各点的保温时间不同, 但均遵循着一个规律, 即保温箱底层测点的保温时间>中层测点的保温时间>上层测点的保温时间。在温度为23 ℃和相对湿度为50%的外界环境下, 30 mm厚的XPS保温箱内蓄冷剂与药品质量比为4∶1时, 能够有效保存药品在2~8 ℃, 保温时间达到24 h以上。建立了挤塑聚苯乙烯保温箱中心点处的外界温度-蓄冷剂与药品质量比-保温时间的三维模型。结论 蓄冷剂结合聚苯乙烯保温箱内部温度可控制在2~8 ℃, 满足冷藏药品短途快递运输的温控要求。
英文摘要:
      This work aimed to study the effect of the coolant amount on the temperature control of extruded polystyrene insulation box. Different amount of coolant was added into the box at three different external temperature and humidity conditions. Influences of the coolant amount on temperature control effect of extruded polystyrene insulation box were studied. When different amount of coolant was added, the temperature holding time at different sites in the insulation box was different, but a common law was obeyed. The temperature distributing law inside the extruded polystyrene insulation box was that the holding time of the bottom test point was longer than the middle than the top. When the mass ratio of coolant and refrigerated drugs was 4∶1, the holding time of the box could reach 24 hours at 23 ℃ and 50% RH. And the 3D model of central point about the external temperature and mass ratio of coolant and refrigerated drugs and holding time was built. The temperature inside the insulation box could be controlled at 2-8 ℃ by combining the extruded polystyrene box and coolant, which could meet the requirement of temperature control for short-distance transportation of refrigerated drugs.
查看全文   查看/发表评论  下载PDF阅读器
关闭

关于我们 | 联系我们 | 投诉建议 | 隐私保护 | 用户协议

您是第22615547位访问者    渝ICP备15012534号-2

版权所有:《包装工程》编辑部 2014 All Rights Reserved

邮编:400039 电话:023-68795652 Email: designartj@126.com

    

渝公网安备 50010702501716号